Hi All,

On 01/10/2023 13:36, Adolf Belka wrote:
> Hi Michael,
>
> On 01/10/2023 12:24, Adolf Belka wrote:
>> Hi Stefan,
>>
>> On 30/09/2023 20:05, Stefan Schantl wrote:
>>> Hello *,
>>>> Hi Michael,
>>>>
>>>> I just ran git pull which took me to commit
>>>>
>>>> build: Add implicit dist() when a makefile is passed  -- followed by
>>>> make and make install.
>>>>
>>>> Running pakfire-builder build beep/beep.nm gave the error message
>>>> "Segmentation fault"
>>>
>>> I can confirm this issue. When the pakfire-builder binary is started it
>>> directly get killed by a SEGV.
>>>>
>>>> Rolling back to
>>>>
>>>> cli: pakfire-builder: Implement "image create"
>>>>
>>>> then worked with beep fine.
>>>>
>>>> Then tried git pull, make, make install again and this time beep
>>>> built
>>>> without any problems. Then I tried sqlite and I got the segmentation
>>>> fault again.
>>>>
>>>> Then I rolled back and sqlite built okay. Then ran sqlite again and
>>>> this
>>>> time part way through building my laptop logged out from my session.
>>>>
>>>> Logged back in and ran sqlite again and this after a short while
>>>> everything froze and I had to reset the laptop.
>>>>
>>>> So rolling back to
>>>>
>>>> cli: pakfire-builder: Implement "image create"
>>>>
>>>> Does not stop the problem happening it just seems to show itself in
>>>> different forms.
>>>>
>>>> I have now rolled back to
>>>>
>>>> cli: pakfire: Implement --yes
>>>>
>>>> which I think is where my last git pull had placed me.
>>>>
>>>> Running pakfire-builder on beep twice and sqlite four times has given
>>>> no
>>>> problems so that commit stage is confirmed good.
>>>
> So far running a build of any existing packages seems to work without 
> a problem. I am then creating a python3-build-0.9.0 build as that 
> version still has setup.py to use that as the bootstrap for the newer 
> python3-build package.
>
> Tested running python3-build-0.9.0 and it goes to download the package 
> and then has a segmentation fault.
>
> I changed the package name to just python3-build but the same 
> segmentation fault occurred.
>
> Maybe I need to roll back to an even earlier commit of the git branch.
>
>
I think I do need to roll back further. After getting a segmentation 
fault every time I tried to build the python3-build package I had 
created, I made another new package, python3-botocore, just to test out.

When I ran the pakfire-builder it started downloading the package but 
then at 75% download everything on the laptop froze and I had to hard 
power off the laptop to get it to reset.

I will try a further rollback and try the new packages again and report 
back what I find.

Regards,
Adolf.

> Regards,
> Adolf.
>>> At this stage the pakfire-builder works fine again and is able to build
>>> packages. But I found an additional issue when using this git state:
>>>
>>> https://bugzilla.ipfire.org/show_bug.cgi?id=13362
>>>
>>> Can you please check, if you are affected by this issue too?
>> I have added my input into the bug report.
>>
>> Regards,
>> Adolf
>>>
>>>>
>>>> Let me know if there is anything else I should try to narrow the
>>>> problem
>>>> down.
>>>>
>>>> Regards,
>>>> Adolf.
>>>>
>>> Best regards,
>>>
>>> -Stefan
>>>
>>
>

-- 
Sent from my laptop