Shouldn’t this rather be called an RFC before we propose this as a patch?

AFAIK this causes problems on some single board computers - so those people who run them would need to give feedback whether this is causing them any regressions.

Best,
-Michael

> On 11 Jul 2022, at 17:07, Peter Müller <peter.mueller(a)ipfire.org> wrote:
> 
> Quoted from https://capsule8.com/blog/kernel-configuration-glossary/:
> 
>> Significance: Critical
>> 
>> In support of Kernel Address Space Layout Randomization (KASLR) this randomizes
>> the physical address at which the kernel image is decompressed and the virtual
>> address where the kernel image is mapped as a security feature that deters
>> exploit attempts relying on knowledge of the location of kernel code internals.
> 
> We tried to enable this back in 2020, and failed. Since then, things
> may have been improved, so let's give this low-hanging fruit another
> try.
> 
> Fixes: #12363
> Signed-off-by: Peter Müller <peter.mueller(a)ipfire.org>
> ---
> config/kernel/kernel.config.aarch64-ipfire | 2 +-
> config/rootfiles/common/aarch64/linux      | 1 +
> 2 files changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/config/kernel/kernel.config.aarch64-ipfire b/config/kernel/kernel.config.aarch64-ipfire
> index 469884b20..9232335ff 100644
> --- a/config/kernel/kernel.config.aarch64-ipfire
> +++ b/config/kernel/kernel.config.aarch64-ipfire
> @@ -471,7 +471,7 @@ CONFIG_ARM64_SVE=y
> CONFIG_ARM64_MODULE_PLTS=y
> # CONFIG_ARM64_PSEUDO_NMI is not set
> CONFIG_RELOCATABLE=y
> -# CONFIG_RANDOMIZE_BASE is not set
> +CONFIG_RANDOMIZE_BASE=y
> CONFIG_CC_HAVE_STACKPROTECTOR_SYSREG=y
> CONFIG_STACKPROTECTOR_PER_TASK=y
> # end of Kernel Features
> diff --git a/config/rootfiles/common/aarch64/linux b/config/rootfiles/common/aarch64/linux
> index 906fde0c3..af96753fc 100644
> --- a/config/rootfiles/common/aarch64/linux
> +++ b/config/rootfiles/common/aarch64/linux
> @@ -9427,6 +9427,7 @@ etc/modprobe.d/ipv6.conf
> #lib/modules/KVER-ipfire/build/include/config/RAID6_PQ
> #lib/modules/KVER-ipfire/build/include/config/RAID6_PQ_BENCHMARK
> #lib/modules/KVER-ipfire/build/include/config/RAID_ATTRS
> +#lib/modules/KVER-ipfire/build/include/config/RANDOMIZE_BASE
> #lib/modules/KVER-ipfire/build/include/config/RANDOMIZE_KSTACK_OFFSET_DEFAULT
> #lib/modules/KVER-ipfire/build/include/config/RAS
> #lib/modules/KVER-ipfire/build/include/config/RASPBERRYPI_FIRMWARE
> -- 
> 2.35.3