Hello,

In my opinion it is sufficient to be able to set these parameters via 
command line.

It should only be made sure that the settings are persitend and not 
overwritten by a reboot or the webif.

-
Daniel

Am 19.11.2020 um 15:56 schrieb Michael Tremer:
> Hello Daniel,
>
> This patch looks good to me.
>
> I had assumed that we automatically enabled STP on all bridges, but apparently we do not.
>
> How do we process with this?
>
> I suppose it is not the most user-friendly way to ask the user to edit the configuration file. This either must be documented somewhere or the zoneconfig.cgi script needs to be extended to allow enabling STP.
>
> Does anyone want to be able to change any STP parameters like priority or cost of the ports?
>
> Best,
> -Michael
>
>> On 19 Nov 2020, at 13:18, Daniel Weismüller <daniel.weismueller(a)ipfire.org> wrote:
>>
>> Signed-off-by: Daniel Weismüller <daniel.weismueller(a)ipfire.org>
>> ---
>> config/udev/network-hotplug-bridges | 4 +++-
>> 1 file changed, 3 insertions(+), 1 deletion(-)
>>
>> diff --git a/config/udev/network-hotplug-bridges b/config/udev/network-hotplug-bridges
>> index 33d6d65ba..7431377bb 100644
>> --- a/config/udev/network-hotplug-bridges
>> +++ b/config/udev/network-hotplug-bridges
>> @@ -81,6 +81,7 @@ MODE="$(get_value "${ZONE}_MODE")"
>>
>> # The name of the virtual bridge
>> BRIDGE="$(get_value "${ZONE}_DEV")"
>> +STP="$(get_value "${ZONE}_STP")"
>>
>> case "${MODE}" in
>> 	bridge)
>> @@ -89,7 +90,8 @@ case "${MODE}" in
>>
>> 		# We need to create the bridge if it doesn't exist, yet
>> 		if [ ! -d "/sys/class/net/${BRIDGE}" ]; then
>> -			ip link add "${BRIDGE}" address "${ADDRESS}" type bridge
>> +			ip link add "${BRIDGE}" address "${ADDRESS}" type bridge \
>> +				$([ "${STP}" = "on" ] && echo "stp_state 1")
>> 			#ip link set "${BRIDGE}" up
>> 		fi
>>
>> -- 
>> 2.28.0
>>