Hello Matthias, hello list,

why is that traffic passing through the loopback interface?!

Thanks, and best regards,
Peter Müller

> Hi,
> 
> perhaps its only me, but after applying this patch for testing purposes
> I don't see any (redirected) urlfilter block pages anymore.
> 
> Only the firewall logs are telling me:
> 
> ...
> REJECT_INPUT lo TCP 192.168.100.254 53464 192.168.100.254 81
> ...
> 
> I had to build a new "Incoming Firewall Access" rule (INPUTFW) allowing
> TCP traffic from (e.g.) 192.168.100.254/32 to GREEN (192.168.100.254) to
> TCP port 81 to see a block page again...
> 
> Only me?
> 
> Best,
> Matthias
> 
> On 14.05.2020 12:36, Michael Tremer wrote:
>> Hello,
>>
>> This is indeed *very* unlikely, but I am okay with this patch being accepted.
>>
>> Acked-by: Michael Tremer <michael.tremer(a)ipfire.org>
>>
>> Best,
>> -Michael
>>
>>> On 13 May 2020, at 21:21, Peter Müller <peter.mueller(a)ipfire.org> wrote:
>>>
>>> This ensures traffic on the loopback interface matches the IPv4
>>> loopback characteristics (source and destination are within 127.0.0.0/8)
>>> and prevents any damage in the unlikely case of non-loopback traffic
>>> being injected/emitted (in)to the loopback interface.
>>>
>>> Cc: Arne Fitzenreiter <arne.fitzenreiter(a)ipfire.org>
>>> Cc: Michael Tremer <michael.tremer(a)ipfire.org>
>>> Signed-off-by: Peter Müller <peter.mueller(a)ipfire.org>
>>> ---
>>> src/initscripts/system/firewall | 6 +++---
>>> 1 file changed, 3 insertions(+), 3 deletions(-)
>>>
>>> diff --git a/src/initscripts/system/firewall b/src/initscripts/system/firewall
>>> index 00512d9fa..409aaf7a9 100644
>>> --- a/src/initscripts/system/firewall
>>> +++ b/src/initscripts/system/firewall
>>> @@ -219,10 +219,10 @@ iptables_init() {
>>> 	iptables -A INPUT -j ICMPINPUT
>>> 	iptables -A ICMPINPUT -p icmp --icmp-type 8 -j ACCEPT
>>>
>>> -	# Accept everything on loopback
>>> +	# Accept everything on loopback if both source and destination are within 127.0.0.0/8
>>> 	iptables -N LOOPBACK
>>> -	iptables -A LOOPBACK -i lo -j ACCEPT
>>> -	iptables -A LOOPBACK -o lo -j ACCEPT
>>> +	iptables -A LOOPBACK -i lo -s 127.0.0.0/8 -d 127.0.0.0/8 -j ACCEPT
>>> +	iptables -A LOOPBACK -o lo -s 127.0.0.0/8 -d 127.0.0.0/8 -j ACCEPT
>>>
>>> 	# Filter all packets with loopback addresses on non-loopback interfaces.
>>> 	iptables -A LOOPBACK -s 127.0.0.0/8 -j DROP
>>> -- 
>>> 2.26.1
>>
>