On Tue, 2018-07-10 at 20:04 +0200, Stefan Schantl wrote:
> Add the required hook_new function and "id" information which have been
> introduced in earlier commits to make this hook work again.
> 
> Signed-off-by: Stefan Schantl <stefan.schantl(a)ipfire.org>
> ---
>  src/hooks/configs/static | 26 +++++++++++++++++++++++++-
>  1 file changed, 25 insertions(+), 1 deletion(-)
> 
> diff --git a/src/hooks/configs/static b/src/hooks/configs/static
> index 91bba8a..37f3d32 100644
> --- a/src/hooks/configs/static
> +++ b/src/hooks/configs/static
> @@ -52,6 +52,8 @@ hook_check_config_settings() {
>  
>  hook_parse_cmdline() {
>  	local protocol
> +	local id="${1}"
> +	shift
>  
>  	while [ $# -gt 0 ]; do
>  		case "${1}" in
> @@ -153,12 +155,34 @@ hook_parse_cmdline() {
>  	fi
>  
>  	# Check any conflicts
> -	if zone_config_check_same_setting "${zone}" "static" "ADDRESS"
> "${ADDRESS}"; then
> +	if zone_config_check_same_setting "${zone}" "static" "${id}"
> "ADDRESS" "${ADDRESS}"; then
>  		error "A static configuration with the same address is
> already configured"
>  		return ${EXIT_CONF_ERROR}
>  	fi
>  }
>  
> +hook_new() {
> +	local zone="${1}"
> +	shift
> +
> +	if zone_config_hook_is_configured ${zone} "static"; then
> +		log ERROR "You can configure the static hook only once for a
> zone"
> +		return ${EXIT_ERROR}
> +	fi

This is incorrect. Why should it only be possible once?

> +
> +	local id=$(zone_config_get_new_id ${zone})
> +	log DEBUG "ID for the config is: ${id}"
> +
> +	if ! hook_parse_cmdline "${id}" "$@"; then
> +		# Return an error if the parsing of the cmd line fails
> +		return ${EXIT_ERROR}
> +	fi
> +
> +	zone_config_settings_write "${zone}" "${HOOK}" "${id}"
> +
> +	exit ${EXIT_OK}
> +}
> +
>  hook_up() {
>  	local zone="${1}"
>  	local config="${2}"