On Tue, 2018-07-10 at 20:04 +0200, Stefan Schantl wrote:

Add the required hook_new function and "id" information which have been introduced in earlier commits to make this hook work again.

Signed-off-by: Stefan Schantl stefan.schantl@ipfire.org

src/hooks/configs/static | 26 +++++++++++++++++++++++++- 1 file changed, 25 insertions(+), 1 deletion(-)

diff --git a/src/hooks/configs/static b/src/hooks/configs/static index 91bba8a..37f3d32 100644 --- a/src/hooks/configs/static +++ b/src/hooks/configs/static @@ -52,6 +52,8 @@ hook_check_config_settings() {

hook_parse_cmdline() { local protocol

• local id="${1}"

• shift

  while [ $# -gt 0 ]; do case "${1}" in

@@ -153,12 +155,34 @@ hook_parse_cmdline() { fi

# Check any conflicts

• if zone_config_check_same_setting "${zone}" "static" "ADDRESS"

"${ADDRESS}"; then

• if zone_config_check_same_setting "${zone}" "static" "${id}"

"ADDRESS" "${ADDRESS}"; then error "A static configuration with the same address is already configured" return ${EXIT_CONF_ERROR} fi }

+hook_new() {

• local zone="${1}"
• shift
• if zone_config_hook_is_configured ${zone} "static"; then

• log ERROR "You can configure the static hook only once for a
  

zone"

• return ${EXIT_ERROR}
  

• fi

This is incorrect. Why should it only be possible once?

• local id=$(zone_config_get_new_id ${zone})
• log DEBUG "ID for the config is: ${id}"
• if ! hook_parse_cmdline "${id}" "$@"; then

• # Return an error if the parsing of the cmd line fails
  

• return ${EXIT_ERROR}
  

• fi
• zone_config_settings_write "${zone}" "${HOOK}" "${id}"
• exit ${EXIT_OK}

+}

hook_up() { local zone="${1}" local config="${2}"