Hello Michael,
thanks for rebasing and resubmitting your patches.
This time everything worked well - merged.
Best regards,
-Stefan
Hi,
I rebased the whole branch and sent a second patchset with the three remaining patches only.
Hope that helps and merges.
-Michael
On 2 Mar 2019, at 16:52, Michael Tremer michael.tremer@ipfire.org wrote:
Why are you asking me that?
What does “git am” tell you? There should be a reason why it didn’t work.
Probably there have been other changes in the section?
-Michael
On 1 Mar 2019, at 19:01, Stefan Schantl < stefan.schantl@ipfire.org> wrote:
Hi,
Did you apply all of them in order?
Yes, I did.
The reported two patches did not apply.
However, the changes on the second patch depends on modifications of the first one, but why does the first one does not apply by using "git am" ?
It is not very helpful to only merge half the patchset.
Did you use pwclient?
-Michael
On 1 Mar 2019, at 17:09, Stefan Schantl < stefan.schantl@ipfire.org> wrote:
Hello Michael,
thanks for working on optimizing the suricata configuration file.
I've merged all of the patches except number "8" and "10" which does not apply with "git am".
When simple adding the changes with "patch" the changes can be applied
- any idea why this happened?
Thanks in advance,
-Stefan
I have worked on suricata's configuration.
My objective was to use more system resources (because suricata did not use much RAM, etc.) to make it faster and to be able to have some deeper decoding and matching.
Please review these changes and let me know what you think.
All in all, suricata should not use more than 1G of RAM which I think is a very good amount. If your system is weaker than that, there is no point in running an IPS.
On my system in my office, this runs with a hand full of rules enabled from the Emerging Threats Community set at around 110MB of RAM.
Michael Tremer (20): Revert "Suricata: detect DNS events on port 853, too" suricata: Set max-pending-packets to 1024 suricata: Set default packet size to 1514 suricata: Set detection profile to high suricata: Drop profiling section from configuration suricata: Drop some commented stuff from configuration suricata: Drop sections that require Rust suricata: Configure HTTP decoder suricata: Allow 32MB of RAM for DNS decoding suricata: Drop parsers I have never heard of suricata: We do not use any IP reputation lists suricata: Log to syslog suricata: Use the correct path for the magic database suricata: Use 64MB of RAM for defragmentation suricata: Use up to 256MB of RAM for the flow cache suricata: Log to syslog like a normal process suricata: Increase memory size for the stream engine suricata: Disable decoding for Teredo suricata: Start capture first and then load rules suricata: Fix syntax error
config/etc/syslog.conf | 2 +- config/suricata/suricata.yaml | 282 +++++----------------
2 files changed, 30 insertions(+), 254 deletions(-)