Hello *,
Hi Michael,
I just ran git pull which took me to commit
build: Add implicit dist() when a makefile is passed -- followed by make and make install.
Running pakfire-builder build beep/beep.nm gave the error message "Segmentation fault"
I can confirm this issue. When the pakfire-builder binary is started it directly get killed by a SEGV.
Rolling back to
cli: pakfire-builder: Implement "image create"
then worked with beep fine.
Then tried git pull, make, make install again and this time beep built without any problems. Then I tried sqlite and I got the segmentation fault again.
Then I rolled back and sqlite built okay. Then ran sqlite again and this time part way through building my laptop logged out from my session.
Logged back in and ran sqlite again and this after a short while everything froze and I had to reset the laptop.
So rolling back to
cli: pakfire-builder: Implement "image create"
Does not stop the problem happening it just seems to show itself in different forms.
I have now rolled back to
cli: pakfire: Implement --yes
which I think is where my last git pull had placed me.
Running pakfire-builder on beep twice and sqlite four times has given no problems so that commit stage is confirmed good.
At this stage the pakfire-builder works fine again and is able to build packages. But I found an additional issue when using this git state:
https://bugzilla.ipfire.org/show_bug.cgi?id=13362
Can you please check, if you are affected by this issue too?
Let me know if there is anything else I should try to narrow the problem down.
Regards, Adolf.
Best regards,
-Stefan