Hello,
What distribution is this?
On 9 Jan 2022, at 13:36, Peter Müller peter.mueller@ipfire.org wrote:
Hello Michael,
thanks for your reply.
You will need to have the —-target switch before the command:
./make.sh —-target=aarch64 build
Don’t forget to fetch the toolchain first and you might need to install a couple of packages that will emulate this architecture. An error message should let you know if anything is missing.
I did so, installed some missing packages, ran "/usr/sbin/qemu-binfmt-conf.sh", downloaded the toolchain for aarch64, and tried to start the build. Sadly, it aborts without any (obvious) error message:
Packaged toolchain compilation Checking for necessary space on disk [ DONE ] Building LFS stage2 [ FAIL ]
Jan 9 13:31:47: Building stage2
ERROR: Building stage2 [ FAIL ] Check /home/pmu/devel/IPFire-development/ipfire-2.x/log/_build.base.log for errors if applicable [ FAIL ] machine:/home/pmu/devel/IPFire-development/ipfire-2.x # cat /home/pmu/devel/IPFire-development/ipfire-2.x/log/_build.base.log Jan 9 13:31:47: Building stage2
That's literally it. Since make.sh does not seem to support a debug/verbose switch, and the output of "bash -x ./make.sh --target=aarch64 build" does not gives any helpful information either, I'm afraid I have to ask for help again.
Well… where does it stop?
QEMU will definitely complain if something isn’t right. Can you see QEMU being executed at all?
-Michael
In case it helps:
# cat /proc/sys/fs/binfmt_misc/qemu-aarch64 enabled interpreter /usr/bin/qemu-aarch64-binfmt flags: P offset 0 magic 7f454c460201010000000000000000000200b700 mask ffffffffffffff00fffffffffffffffffeffffff
Thanks in advance, and best regards, Peter Müller