Hi Bernhard,
On 09.03.2019 22:19, Bernhard Bitsch wrote:
...
On 09.03.2019 21:15, Matthias Fischer wrote:
...
Could you please check the resulting values for ON and OFF settings?
Here:
wlanap.cgi - ON is checked: /var/ipfire/wlanap/hostapd.conf => noscan=1 /var/ipfire/wlanap/settings => NOSCAN=on
wlanap.cgi - OFF is checked: /var/ipfire/wlanap/hostapd.conf => noscan=0 /var/ipfire/wlanap/settings => NOSCAN=OFF
Do you get the same results?
Best, Matthias
No, it's just the other way. Just as the original line reads, I think. I also checked the functionality. If I check "Neighbourhood scan=off" hostapd generates a 40MHZ signal, and vice versa. The semantics are ok also: "Neighbour scan=off" --> scan --> noscan=0.
Ok, I think I mixed this up somehow before. After correcting the above line back to original I get:
wlanap.cgi - ON is checked: /var/ipfire/wlanap/hostapd.conf => noscan=0 /var/ipfire/wlanap/settings => NOSCAN=off
wlanap.cgi - OFF is checked: /var/ipfire/wlanap/hostapd.conf => noscan=1 /var/ipfire/wlanap/settings => NOSCAN=on
And the appropriate choice remains checked. Duh!
Correct!?
Best, Matthias