Hello,

there was a limit prior to Core Update 100 but this should have gone away and actually 20 NICs should be shown by now.

Did you try to scroll down? Are there any errors shown?

What is the output of "ip link"?

Best, -Michael

On Thu, 2016-04-28 at 16:52 +0200, g6094199@freenet.de wrote:

He guys!   i recently installed IPFire core 100 to an Watchguard Firebox X 750e/1000e. All installed to an CF-card, booted up fine. Came to the general setup and asked to map the nics to an interface. While the x750 has 8 nics (4x Marvell 88E8001, 4x 88E8053) only 6 nics are shown in the setup menue via serial port. which seems to be a limitation by the GUI or a bug.   I can see als of the interfaces on cli after i finished the initial setup   lspci: 01:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 19) 02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 19) 03:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 19) 04:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 19) 05:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller (rev 13) 05:01.0 Ethernet controller: Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller (rev 13) 05:02.0 Ethernet controller: Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller (rev 13) 05:03.0 Ethernet controller: Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller (rev 13)   I also can use them. So it seems to be a limitation/bug of the setup menue?!   Any thoughs?     regards sash

---

Mail & Cloud Made in Germany mit 3 GB Speicher! Jetzt kostenlos anmelden