Based on the examples found in strongswan we need to specific the source IP for our routes through an IPsec VPN. If we have no source IP (a router can route packages which do not belong to the network assigned to our zones) we set no routes, but clients can still use the tunnel.
For IPsec VPNs in tunnel mode we also need the device which has the ${PLUTO_ME} IP address asigned.
The source IP is determined ip_get_assigned_addresses_from_net() the device is determined by the device_get_by_ip_address() function.
For tunnel mode see: https://www.strongswan.org/testing/testresults/ipv6-stroke/net2net-ip4-in-ip...
Fixes: #11629
Signed-off-by: Jonatan Schlag jonatan.schlag@ipfire.org --- src/helpers/ipsec-updown | 46 +++++++++++++++++++++++++++++++++++++++------- 1 file changed, 39 insertions(+), 7 deletions(-)
diff --git a/src/helpers/ipsec-updown b/src/helpers/ipsec-updown index 12ead03..3764085 100644 --- a/src/helpers/ipsec-updown +++ b/src/helpers/ipsec-updown @@ -86,13 +86,45 @@ case "${PLUTO_VERB}" in ;; esac
- # Set routes - if isset INTERFACE; then - cmd ip route add "${PLUTO_PEER_CLIENT}" \ - dev "${INTERFACE}" - else - cmd ip route add "${PLUTO_PEER_CLIENT}" \ - via "${PLUTO_PEER}" + #Get sources IP for routes + SRC_IP=($(ip_get_assigned_addresses_from_net \ + "${PLUTO_MY_CLIENT}" "permanent")) + + # Set routes if we have a source IP. + # If not the machine does not has a leg on the net + # and we can go on without routes. + if isset SRC_IP; then + # We take the lowest source IP we found, + # which is ugly because the value is unpredictable. + SRC_IP=${SRC_IP[0]} + + if isset INTERFACE; then + if ! cmd ip route add \ + "${PLUTO_PEER_CLIENT}" \ + dev "${INTERFACE}" \ + src "${SRC_IP}"; then + log ERROR \ + "Could not set routes for ${PLUTO_PEER_CLIENT}" + fi + else + # Get the device which we use to peer with the other site. + ME_DEVICE = "$(device_get_by_ip_address "${PLUTO_ME}")" + + # We can only go on if we found a device. + if isset ME_DEVICE; then + if ! cmd ip route add \ + "${PLUTO_PEER_CLIENT}" \ + dev "${ME_DEVICE}" \ + proto static \ + src "${SRC_IP}" \ + table 220; then + log ERROR \ + "Could not set routes for ${PLUTO_PEER_CLIENT}" + fi + else + log ERROR "Could not get device for ${PLUTO_ME}" + fi + fi fi ;;